Close icon Close icon

SMARTProfile II

DISTRIBUTED FIBER OPTIC SENSOR FOR CIVIL AND GEOTECHNICAL INTEGRITY MONITORING

High-accuracy distributed strain and temperature sensing.
Fully redundant configuration. For embedded or surface mounted installation.

Description

The DiTeSt SMARTprofile combined strain and temperature sensors are designed for distributed deformation (average strain) and temperature monitoring over long distances, using BOTDR / BOTDA (Brillouin scattering) technologies.         

The DiTeSt SMARTprofile sensor consists of two bonded and two free single mode optical fibers embedded in a polyethylene thermoplastic profile. The bonded fibers are used for strain monitoring, while the free fibers are used for temperature measurements (quantitative if sensor deformation <0.2%, qualitative if sensor deformation >0.2%) and to compensate temperature effects on the bonded fibers. For redundancy, two fibers are included for both strain and temperature monitoring. The profile itself provides good mechanical, chemical and temperature resistance. The small size of the profile makes the sensor easy to transport and install by embedding in concrete or mortars, gluing or clamping. The SMARTProfile sensor is designed for use in environmental conditions typically found in civil, geotechnical and oil & gas applications. However, this sensor cannot be used in extreme temperature environments, nor in environments with aggressive chemicals. It is not recommended for installation under permanent UV radiation (e.g. sunshine) without an additional cover or aluminum tape protection.

The SMARTprofile sensing cable is delivered on spools with all the necessary accessories such termination and connectors (E2000, FC-PC or other).

Specifications
Temperature Range  
Operating temperature: -40 °C to +60 °C
Storage temperature: -5 °C to +40 °C
Installation temperature: -5 °C to +50 °C
Pigtails and connectors: -40°C to +60°C
   
Technical Data  
Temperature compensation: through single mode temperature fibers with DiTeSt BOTDA / BOTDR, if strain ≤ 0.2 %
through multi mode temperature fibers with DiTemp ROTDR, insensitive to mechanical strain
Calibration: during production
Strain range: -1.5 % to +1.5 %
Maximal length: 800 m / reel, more upon request
Dimensions (W x H): 8.0 mm x 4.0 mm
Weight: 22 ± 0.5 kg/km
Max tensile strain: 1.5%
Min bending radius: 400 mm (long term)
Hydrostatic pressure: 300 kPa (3 bar)
   
Fiber Types  
Fiber support (strain): 2 SMF 9 / 125 um Polymide coated ITU-T G.652.D compliant
Fiber support (temperature): 2 SMF 9 / 125 um Acrylate coated ITU-T G.652.D compliant
2 MMF 50 / 125 um Acrylate coated ITU-T G.651 compliant
Fiber attenuation (cabled @ 20 °C): ≤ 1.2 dB @ 1310 nm – SMF strain ≤ 3.0 dB @ 850 nm – MMF temperature
≤ 1.0 dB @ 1550 nm – SMF strain ≤ 1.0 dB @ 1300 nm – MMF temperature
≤ 0.4 dB @ 1310 nm – SMF temperature
≤ 0.3 dB @ 1550 nm – SMF temperature
Number of fibers: 2 SMF strain fibers + 2 SMF temperature fibers + 2 MMF temperature fibers
Ordering Info

11.1030 DiTeSt SMARTProfile Sensor

Accessories:

  • Cable termination with connectors
  • Junction box
  • Splice box
Down arrow
close

Search Telemac

Searching...